Hose for fresh air 100l w Goes from inside car at right front trim panel to front of heater, about six inches in diameter
From heater to bilge blower hose junction tee on left side of gas tank.
Right side. From heater to right defroster outlet duct.
To seal bilge blower screen to left front fender.
Goes along entire top frame. When engine lid is down, it seals against this seal to prevent hot engine compartment air from being pulled through radiator by fan.
New production black seal base fits around base of front marine light lens to keep water out of light assembly. If seal is defective, moisture will damage the chrome, red and green coatings on the interior side of the marine light lens.
Fastens to left side of upper shroud where shroud rests against body.
WEATHERSTRIP SIDE INTAKE SEAL, RIGHT
Trims defroster duct outlet holes on top of dash.
Special pressure type made in Germany.
Special high pressure line, oil cooler to engine. Two needed per car.
One fits on top of cylinder head, the other at the bottom of water pump assembly.